How do I reset my Mercury oil Change message?

How do I reset my Mercury oil Change message?

Reset oil service light Mercury Mariner

1. Turn the ignition to run, one position before starting engine.
2. Press the SET control to access the system check function.
3. Press and release the SETUP control to display “OIL LIFE = XXX% HOLD RESET = NEW”.
4. Press and hold the RESET control for two seconds and release.

How do I reset my oil life monitor?

Oil Life Monitor Reset Procedure

1. Turn ignition switch to ON or RUN position with engine off.
2. Depress accelerator pedal slowly to wide open throttle 3 times within 5 seconds.
3. If CHANGE ENG OIL light flashes for 5 seconds, oil life monitor is reset.

How do I reset my car computer after an oil change?

Insert the key into the ignition and turn it to the “on” position without starting the engine. Depress the gas pedal slowly three successive times within 10 seconds. At this point, the system should have reset. You can verify by turning the ignition off and then on again.

Can you drive a car with 15 oil life?

Yes it will be okay. But the best thing for you to do is check the oil level. Having oil that is overdue for a change is not nearly as bad as driving around low on oil. Today’s vehicle manufacturers are recommending oil changes at 5, 10, and even 15 thousand miles.

What does it mean when oil life is negative?

Negative mileage means your vehicle has passed the maintenance required point. Immediately have the indicated maintenance done by your dealer. When the remaining engine oil life is 0 percent, the engine oil life indicator will blink. The display comes on every time you turn the ignition switch to the ON (II) position.

How do I reset my Mercury?

Mercury, Mercury Mini, & PCD Recovery

1. Power cycle the phone.
2. When the green light bar starts to blink, press and hold the volume + and the mic mute buttons.
3. Select factory restore.

How do you reset the oil life on a Mercury Mountaineer?

Reset oil service light Mercury Mountaineer

1. Turn the ignition to run, one position before starting engine.
2. Press and hold the OIL CHANGE RESET control and press the RESET control while the display is still counting down the five seconds to reset.

How do you reset the oil life on a pedal?

Press both the accelerator and brake pedals at the same time. Keep both pedals fully pressed. After three seconds, the Service: Oil reset in progress.